In the bridge construction and housing construction, steel bars will be used, and people also know the use and function of the steel bars. However, the steel bars need to be cut or bent during use, so the steel bar bending machines become indispensable for the processing of steel bars One of the tools, then the use of steel bending machine safety precautions and what are the rules? We look at the introduction below.

 Bending machine use Note:

 The emergence of steel bending machine to replace the manual processing of steel, effectively improve the work efficiency, but also a good guarantee of the quality of the products, we must pay attention to check the table before using the machine to keep the level with the bending machine, Check the performance of the machine is not in good condition, ready to run before a variety of mandrel tool files, in accordance with the regulations to adjust the mandrel forming shaft and block iron shaft.

 Before processing the steel, the machine must pay attention to the first air running, the normal speed before they can be bent into the turret side of the North Bend fixed one of the gap among them, the other end of the bar need to be hand pressed, and then the fuselage fixed to ensure that After the security can be reinforced in the side of the bend.

Steel bending machine safety rules:

 First of all, we should pay attention to prepare a variety of mandrel and Gong Gong, and then check the mandrel, stop, turntable there is no damage and cracks, the protective cover here is tightened, after the air is OK to work properly.

 Secondly, when bending the steel bar, the steel bar must be close to the baffle plate. When the machine is running, it can not replace the mandrel, the pin, the changing angle and the speed regulating activities. At the same time, the steel bar can not be refueled and cleaned, thus ***oiding There is an unnecessary danger.

In addition, when bending steel bar, if the diameter and number of reinforcing bars exceed the specified speed of the machine, do not go on. In order to ***oid the collision with people and objects, pay attention to the replacement of plugs. If you want to refuel and When cleaning, be sure to wait until the machine stops working before proceeding.